
General Troubleshooting Guide - 2
When any air onditioner malfunction is noted, immediately switch off the power supply to the unit and contact the
local dealer, if necessary. Some simple trouble shooting tips are given below :
TROUBLE PROBABLE CAUSE SUGGESTED ACTION
1. Fan does not work 1. No power supply 1. Check power supply
2. Fan capacitor faulty 2. Contact local dealer
3. Fan motor faulty 3. Contact local dealer
4. Switch Faulty 4. Change switch
2. Fan work, but compressor 1. Thermostat setting too high 1. Reset thermostat
does not work 2. Compressor capacitor faulty 2. Contact local dealer
3. Compressor faulty 3. Contact local dealer
4. Compressor contactor faulty 4. Contact local dealer
3. Both fan and compressor 1. Power failure 1. Operate when power suppl resume
does not work 2. Starter trip 2. Reset starter
3. Fuse blown in power switch or 3. Check and replace fuse
operating unit
4. Air-Conditioner work but 1. Thermostat setting too high 1. Reset thermostat
cooling not satisfactory 2. Door and/ or windows not closed 2. Close door and/ or windows
3. Condenser coil dirty 3. Clean condenser coil
4. Some objects blocking the inlet 4. Remove the objects
and / or outlet of the unit
5. Refrigerant charge too low 5. Contact local dealer
45
Mini Chiller: Trouble Shooting Guide
When any malfunction is occurred, immediately switch off the power supply to the unit, and ontact the local dealer,
if necessary. Some simple trouble shooting tips are given below.
SYMPTOMS POSSIBLE CAUSES REMEDIAL ACTION
1. Compressor does not start * No powersupply. * Check power supply
* Fuses blown or automatic circuit * Look for short circuit or grounded wires
breakdown open in motor windings.
Replace fuses and reset circuit breakers
when the fault has been corrected.
Check tightness and soundness of all
electrical connection.
* Defective contactor or coil * Repair or replace.
* Unit is stopped because a safety * Determine the type of safety shut down
has tripped. and correct the unit is restarted.
* Loose wires * Check wire connection and tighten
terminal screw
* Compressor faulty * Contact local dealer
2. Fan does not * No powersupply. * Check power supply
* Fan motor faulty * Contact local dealer
3. Air conditioning does work, * Thermostat setting too high * Reset thermostat
but insufficient cooling * Condenser coil dirty * Contact local dealer
* Obstacle blocking air inlet or * Remove the obstacle
outlet of the unit
* Insufficient refrigerant in * Contact local dealer
the system
* improper water flow rate * Contact local dealer
* Water in the system is * Contact local dealer
contaminated
46
Comentários a estes Manuais