McQuay M5MSX Especificações descarregar pdf (Página 22)

M5MSX-2009

Electrical Wiring Connection

IMPORTANT : The gures shown in the table are for information purpose only. They should be checked

and selected to comply with the local/national codes of regulations. This is also to the type of

installation and conductors used.

INDOOR UNIT D

TERMINAL BLOCK

INDOOR UNIT C

TERMINAL BLOCK

INDOOR UNIT B

TERMINAL BLOCK

INDOOR UNIT A

TERMINAL BLOCK

REWOP

YLPPUS

There must be a double pole switch with

a minimum 3 mm contact gap and fuse

/ circuit breaker as recommended in the

fixed installation circuit.

• All wiring must be connected accordingly to the diagram above, with reference to the piping connection.

Mismatch any wiring with different piping will cause severe damage to the system.

• All wires must be rmly connected.

• All wires must not touch the refrigerant piping, compressor or any moving parts of the fan motor.

• The connecting wires between the indoor unit and the outdoor unit must be clamped on the wire

clamps and the cable tie (push releasable) at the indoor unit and outdoor unit respectively as shown in

the gures.

• The power supply cord must be equivalent to H05RN-F (245IEC57) which is the minimum requirement.

MAIN CONTROL BOARD EARTH WIRE

FAN EARTH WIRE

POWER SUPPLY

CABLE

CABLE TIE

(PUSH RELEASABLE)

INTERCONNECTION

CABLE

Application Information

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 67 68

Sem comentários

McQuay M5MSX Especificações Página 22