McQuay MDS300B Guia de Instalação descarregar pdf (Página 71)

-71-

Design & installation Guide For McQuay MDS Multi System

● Connecting the hose to the drainage pipe of outdoor unit;

● Pour the water through the water inlet port and check if there is any water leakage;

● When the test is finished, connect the other side of the hose to the drainage pipe of the indoor

unit.

● The unit must be installed horizontally in order to prevent the water leakage and

condensated water from generating.

■ Installation of front panel

● There is only one direction to install the front panel, which depends on the position of

indicator light and motor wiring;

● The installation paper must be taken away before the installation of front panel;

● Open the two bolts of the front grille, then take out the filter and front grille;

● Tighten the front frame to the indoor unit with four bolts and flat gasket and screw it to a

tight extend, which can prevent the air leakage;

● Connecting the indicator light and motor wiring to the indoor unit (wire controlling type

without indicator light connecting wire).

【Note】Fix the front frame to avoid cooling leakage, which may cause water to coagulate and generate water drop.

【Note】This type of units adopts drainage pump to drain condensate water, and installing the unit horizontally is

to avoid water leakage and coagulation.

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 119 120

Sem comentários

McQuay MDS300B Guia de Instalação Página 71